Skip to main content

The Crucible Process Of Steel Making

 In The crucible process of  making steel, mixtures of wrought iron, steel scrap and ferro manganese are melted down with charcoal in the air tight crucible. Other ferro alloys may be added when alloy steel is produced by this process. In this crucible process, Carbon is added to the iron as the carbon content of the wrought iron is low. Necessary carbon is taken up by the metal from charcoal during melting. After the materials are melted and thoroughly alloyed, the crucibles are taken from the furnace known as regenerative furnace which is heated by gaseous fuel as in the open - hearth furnace , and finally the steel is poured into ingot mold. The length of time between placing the crucible in the furnace and withdrawing the crucible is approximately four hours.




The process is primarily a melting and alloying process and no refining of the metal takes place in the crucible. 

Labels:

Comments

  1. AnnuDecember 14, 2023 at 2:03 AM

    Thanks for sharing an informative blog on the crucial process of steel making. Elevate your exceptions with BK Steel They proudly craft alloy steel that exceeds industry standards.

    ReplyDelete

Post a Comment

Popular posts from this blog

THROTTLE GOVERNING OF STEAM TURBINES

Steam Pressure at inlet to a steam turbine is reduced by throttling process to maintain the speed of the  turbine constant at part load and hence this method of governing is called "Throttle Governing".  Construction : Throttle governing system consists of  a centrifugal governor, a lever , an oil pump , a pilot piston , control valve , a relay piston and a throttle valve. The throttle valve is moved by a relay piston. The relay piston is actuated by pilot piston control valve. There are two piston valves covering ports in the pilot piston control valve without any overlap. These piston valves are operated by lubricating oil supplied by a gear pump at 2 to 4 bar. The oil returns to the drain from this chamber.  Working : When the turbine works on full rated load, the throttle valve will remain open. When the load is decreased, the energy output of the turbine becomes in excess and the turbine shaft speed increases. Hence, governor sleeve will lift. The upward movement of the
Post a Comment
Read more

ELECTRICAL COMPARATORS AND ITS WORKING

Electrical Comparators are used as a means of  detecting and amplifying small movements of a work contacting elements. An electrical comparator consists essentially of  a pick-up head or transducer for converting a displacement into a corresponding change in current and a meter or recorder connected in the circuit to indicate the electrical change, calibrated to show in terms of displacement. Generally, an amplifier is needed to provide the requisite sensitivity and to match the characteristics of different parts of  the circuit. Electrical comparators can be classified according to the electrical principle used in the pick-up head. Most of the comparators use either a differential transformer, an inductance bridge, a strain gauge or a capacitor as a means of detecting movement of the gauging element. There are different types of  electrical comparators. One kind called an electrolimit gauge is used to check or measure the outside diameter of a  roll. The object to be checked is place
Post a Comment
Read more

Advantages And Disadvantages Of Air Refrigeration System :

 Advantages Of  Air Refrigeration : 1. The refrigerant used namely air is cheap and easily available. 2. There is no danger of fire or toxic effects due to leakages. 3. The weight to ton of refrigeration ratio is less as compared to other systems. Disadvantages Of Air Refrigeration : 1. The quantity of  Refrigerant used per ton of refrigeration is high as compared to other systems. 2. The COP of the system is very low. Therefore running cost is high. 3. The danger of frosting at the expander valves is more as the air contains moisture content. 
Post a Comment
Read more